left right

Dobrodošli na Player e-shop!


Garancija najnizih cena

pobedićemo svaku konkurentsku cenu!


SYMETRIX

Radius

Šifra Proizvoda: 545670

Napiši prvi komentar za ovaj proizvod





call

Dostupnost:

Na lageru


Prikazana cena je za komad.

Kratak opis

Dante™ in Our DNA. Radius DSPs are equipped with 128 (64×64) redundant Dante channels. The Dante protocol enables ultra-reliable multi-channel audio networking over IP. Together, Symetrix and Dante provide the fastest possible way to implement, control, and maintain a system of networked DSPs and accessories – including third party Dante-enabled end points.

Pogledaj proizvod iz više uglova:


*Istaknute cene su informativnog karaktera.
Pre svake kupovine i poručivanja ovog uređaja, pozovite jednu od Player prodavnica putem navedenih brojeva telefona, kako biste dobili najbolju cenu.

General Specifications

  
Processors 1 x Analog Devices SHARC 21489 @ 400 MHz SIMD.
Raw processing capacity 400 MIPS, 1.6 GFLOPS.
Sampling rate 48 kHz, ± 100 ppm.
Frequency response (A/D/A) 20 Hz – 20 kHz, ± 0.5 dB.
Dynamic range (A/D/A) > 114 dB, A-weighted.
Channel separation (A/D/A) > 108 dB @ 1 kHz, +24 dBu.
Latency (A/D/A) 0.88 mS, inputs routed to outputs.
Delay memory 174 mono seconds.
Analog control inputs 0-3.3 VDC.
Recommended external control potentiometer 10k Ohm, linear.
Logic outputs Low (0V) when active, pulled high (5V) when inactive.
Logic output maximum external power supply voltage / current sinking 24 VDC / 50 mA.
Logic output maximum output current 10 mA.
THD + Noise < -85 dB (unweighted); 1 kHz @ +22 dBu with 0 dB gain.
RS-232 accessory serial I/O 57.6 kbaud (default), 8 data bits, 1 stop bit, no parity, no flow control wired straight-through, only pins 2, 3, and 5 required.
RS-485 serial I/O 38.4 kbaud (default) 8 data bits, 1 stop bit, no parity, no flow control. May be broken out of ARC port.
Ethernet Cable Standard CAT5, maximum device to device length = 100 meters.
Dante Cable Standard CAT6, maximum device to device length = 100 meters.
ARC Cable Standard CAT5, distance dependent upon load and number of devices.
Maximum stored presets 1000.

Analog Inputs

  
Connectors 3.81 mm terminal blocks.
Number of inputs Twelve (12) switchable balanced mic or line level.
Nominal input level +4 dBu with 20 dB of headroom.
Maximum input level +23 dBu.
Mic pre-amp gain 0, 11.8, 24, 44 or 54 dB switchable with ± 24 dB trim.
Mic pre-amp EIN < -127 dB with 150 Ohm source impedance.
CMRR > 76 dB @ 1 kHz, unity gain.
Input impedance 8 k Ohms balanced, 4 k Ohms unbalanced.
Phantom power (per input) +48 VDC @ 10 mA maximum.
Dynamic range > 115 dB, A-weighted.
THD + Noise < -94 dB, unweighted; 1 kHz @ +22 dBu with 0 dB gain.
Latency 0.28 mS.

Analog Outputs

  
Connectors 3.81 mm terminal blocks.
Number of outputs Eight (8) balanced line level.
Nominal output level +4 dBu with 20 dB of headroom.
Maximum output level +24 dBu (+22.8 dBu into a 2 k Ohm minimum load).
Output impedance 300 Ohms balanced, 150 Ohms unbalanced.
Dynamic range > 117 dB, A-weighted.
THD + Noise < -95 dB, unweighted; 1 kHz @ +22 dBu with 0 dB gain.
Latency 0.60 mS.

Mechanical Data

  
Space Required 1U (WDH: 18.91 in. x 9.5 in. x 1.72 in. / 48.02 cm x 24.13 cm x 4.37 cm). Depth does not include connector allowance. Allow at least 3 inch additional clearance for rear panel connections. Additional depth may be required depending upon your specific wiring and connections.
Electrical 100-240 VAC, 50/60 Hz, 45 Watts maximum universal input. No line voltage switching required.
Ventilation Maximum recommended ambient operating temperature is 30 C / 86 F. Ensure that the left and right equipment sides are unobstructed (5.08 cm, 2 in. minimum clearance). The ventilation should not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc.
Shipping Weight 13 lbs. (5.9 kg).
Certifications or Compliance UL 60065, cUL 60065, IEC 60065, EN 55103-1, EN 55103-2, FCC Part 15, RoHS.

 Scroll To Top